HatDrive! Dual

Dual NVMe HAT for 2230 and 2242 NVMe drives. Supports Gen 2 PCIe speeds.
Compatible with Raspberry Pi 5.

Purchase

Packaging contents

- HatDrive! Dual board
- 40mm PCIe FPC cable with controlled impedance
- 4 standoffs
- 3 M.2 drive standoffs (one spare) combined with a nut and a bolt
- 9 M2.5 screws

Assembly instructions

  1. Begin with inserting the FPC ribbon cable into your board. Use the alignment triangle to determine the proper direction, check the picture above for reference.
  2. Insert the NVMe drives using the provided standoffs.
  3. Attach 4 metal standoffs to the board using M2.5 screws.
  4. Insert the PCIe cable into your Pi 5.
  5. Install the board underneath your Pi 5. Please note that the NVMe should not be facing the Pi 5 board. If you install the board incorrectly it will not turn on.
  6. Power on the board, the PWR LED should be now on. If this is not the case please update the firmware on your Pi 5 or enable PCIe (check tutorials below).

Drivers

No drives are required for NVMe SSDs on the Raspberry Pi 5. We recommend regularly updating the firmware to benefit from constantly improving drive compatibility.

Compatibility

HatDrive! Dual is compatible with Raspberry Pi 5 and other Single Board Computers with the 16-pin PCIe connector (for instance the Radxa 5C/5C Lite).

Important Notice: Please be aware that booting from NVMe storage through a PCIe switch is currently not supported. Users planning to utilize NVMe storage should consider this limitation when designing their projects.

Tutorials

Get started with your board quickly with our tutorials.

Browse tutorials