Hat Ai! Dual

Google Coral Dual Edge TPU HAT.
Compatible with Raspberry Pi 5.

Purchase

Packaging contents

- Hat Ai! Dual board
- 40mm PCIe FPC cable with controlled impedance
- 4 standoffs
- 1 M.2 drive standoff
- 9 M2.5 screws

Assembly instructions

  1. Begin with inserting the FPC ribbon cable into your board. Use the alignment triangle to determine the proper direction, check the picture above for reference.
  2. Insert your Edge TPU using the provided standoff.
  3. Attach 4 metal standoffs to the board using M2.5 screws.
  4. Insert the PCIe cable into your Pi 5.
  5. Install the board underneath your Pi 5. Please note that the TPU should be facing the Pi 5. If you install the board incorrectly it will not turn on.
  6. Power on the board, the PWR LED should be now on. If this is not the case please update the firmware on your Pi 5 or enable PCIe (check tutorials below).

Drivers

Google Coral Edge TPU needs the Gasket kernel driver. Please check our installation tutorial listed below. We recommend regularly updating the firmware to benefit from constantly improving PCIe compatibility.

Compatibility

Hat Ai! Dual is compatible with Raspberry Pi 5 and other Single Board Computers with the 16-pin PCIe connector (for instance the Radxa 5C/5C Lite).

This board is only meant to be used with the Coral Edge TPU, other devices might not work since the Dual Edge TPU has a unique pinout for the second PCIe lane.

Tutorials

Get started with your board quickly with our tutorials.

Browse tutorials